Interior Wood Trim Removal

[Markunderwood]

Hello
Ok what is the trick to remove the wood trim piece on the pillar between the front and rear doors? This is the piece directly below the interior side light. I don't see any obvious wood screws to remove on the inside of the car. Thanks in advance for the help.

One more thing, I have been quoted $10K to have the entire wood set (31 pieces) re veneered with walnut burl from Madera Concepts. This sounds steep, but maybe this is the going rate. Any other recommendations for companies providing this service?

[Horse Power Junkie]

Start with the lower parts, the top part will slide down.

Is you veneer really that bad it has to be replaced? Normally a removal of the old laquer (I used paint remover) and respray will be enough.

[David Reilly]

Mark,
The instructions are om page N.23 of the Service Manual (attached)
Cheers
David

[Jose]

$10 grand sounds steep, very steep.

Get an estimate from Saul Chaplin at British Auto Wood in Orlando Florida begore you dive.

www.britishautowood.com

[Markunderwood]

Thanks for the info, you guys always come through. Yes the veneer is gone on most pieces and the remaining veneer is lifting off and cracked. I will check into British auto woods to get a comparison. Thanks again.

[Tom Hoffman]

Mark,

I do have a parts car with most of the wood still in place. The finish is, of course, all shot but but most of the wood is in good condition. I'll take a look at it tomorrow to verify that. I'll get back to you.

[Chris Dixon]

Don't know if this works for US residents but there are a couple of guys in the UK who will refurb or supply an exchange set for around £800. I decided to amuse myself by going to night school to learn furniture restoration. Interestingly I found that a heat gun gently applied made removal of the old lacquer fairly easy when paint stripper wouldn't budge it.

[deelcee]

try these guys on ebay.uk
thegrangastonproject

[DevilDog]

Just saw this post....sorry for being so late with a response. I had all my wood completely redone last year by Saul at BritishAutowood. I paid $4,500. He does a great job and I chose him over everybody else.
Good luck

13199330_1163588536998924_1447011162_o.jpg (91.44 KiB) Viewed 4517 times

13210939_1163523623672082_622390354_o.jpg (87.2 KiB) Viewed 4517 times

13210960_1163588483665596_1771405582_o.jpg (126.03 KiB) Viewed 4517 times

13227556_1163494010341710_2542335989520536298_o.jpg (108.84 KiB) Viewed 4517 times

13230873_1163588480332263_800717739_o.jpg (93.79 KiB) Viewed 4517 times

13235134_1163494003675044_5929357856109497637_o.jpg (91.98 KiB) Viewed 4517 times

13235425_1163494007008377_6015880715103363785_o.jpg (103.96 KiB) Viewed 4517 times

13242161_1163523620338749_870925385_o.jpg (114.81 KiB) Viewed 4517 times

[Jose]

Saul is not cheap but his work is world-class. I know him and have been to his modest shop. He is from Wales. Owns a 340 and a 420.