Page 1 of 1
Rear Plate Illumination Assembly
Posted: Fri Jun 01, 2018 2:45 pm
by DevilDog
- RearLightAssembly.jpg (259.82 KiB) Viewed 2703 times
Part number C17188.
Mine was re-chomed 3 times and one spot could not be fixed. Looking for one that is perfect or used, not pitted, and can be re-chromed. Do not need the lenses, only the chrome assembly.
Thanks,
Joe
Re: Rear Plate Illumination Assembly
Posted: Fri Jun 01, 2018 9:03 pm
by cass3958
These are made of Unobtainium mixed with Unchromium.
I have a decent spare and I know Nigel was looking at one at the Jaguar show last year but they are very difficult to find in a decent condition. Yours looks superb compared to mine so I might do a swap with my decent one if you are going to rechrome it. PM me your email again and I will send you a photo of mine. That sounds rude Joe but you know what I mean.
ps where is the bit on this one that could not be fixed?
Re: Rear Plate Illumination Assembly
Posted: Sat Jun 02, 2018 1:58 pm
by Jose
Joe it is called Plinth. I had a perfect one a month ago but sold it.
Re: Rear Plate Illumination Assembly
Posted: Sun Jun 10, 2018 1:44 pm
by DevilDog
Rob,
PM Sent.
Here are my photos.....you can see the small bubble in photo #4. Could not be repaired.
- 20180609_110857.jpg (4.59 MiB) Viewed 2666 times
- 20180609_110915.jpg (4.87 MiB) Viewed 2666 times
- 20180609_110926.jpg (4.5 MiB) Viewed 2666 times
- 20180609_111042.jpg (3.33 MiB) Viewed 2666 times
Re: Rear Plate Illumination Assembly
Posted: Wed Jul 04, 2018 3:01 pm
by DevilDog
Rob.....are you there......
Joe
Re: Rear Plate Illumination Assembly
Posted: Wed Jul 04, 2018 8:36 pm
by cass3958
Sorry Joe been really busy last couple of weeks. I have your email address and will contact you either later tonight or tomorrow with photos.
Re: Rear Plate Illumination Assembly
Posted: Wed Jul 25, 2018 12:16 am
by DevilDog
Just to put this post to bed.....Rob and I are swapping and I will rechrome his. Thanks everyone.