Page 4 of 4
Re: Clutch fluid bottle lid
Posted: Wed May 22, 2019 9:26 am
by Glyn Ruck
cass3958 wrote: ↑Wed May 22, 2019 7:27 am
Great ~ thanks guys, I learned something more about S Types.
It would seem quite a major change to make so late in the production cycle of a model
I am disappointed that you didn't already know this Glyn.lol.
LOL! I try to learn new things every day. Keeps my tired old mind active.
This is the value of the collective knowledge & wisdom of members of this forum. Always someone that knows or is prepared to do the research or collective snippets of knowledge make up the whole.
Re: Clutch fluid bottle lid
Posted: Thu May 23, 2019 6:29 pm
by Albion
Is this bolt correct for holding the brake fluid reservoir?
Re: Clutch fluid bottle lid
Posted: Thu May 23, 2019 8:06 pm
by Orlando St.R
Albion wrote: ↑Thu May 23, 2019 6:29 pm
Is this bolt correct for holding the brake fluid reservoir?
It seems unlikely with a Philips head like that. More likely a plain hex bolt, I would expect. Is it in the Parts Manual?
Re: Clutch fluid bottle lid
Posted: Thu May 23, 2019 8:52 pm
by cass3958
Albion this is an original bracket with screw that is in my many boxes of parts. It is a flat head screw with a small nut on the back.
Re: Clutch fluid bottle lid
Posted: Thu May 23, 2019 9:09 pm
by Glyn Ruck
That's correct Rob.
Re: Clutch fluid bottle lid
Posted: Fri May 24, 2019 4:47 am
by Albion
Thanks guys. Good day.
Re: Clutch fluid bottle lid
Posted: Wed Dec 22, 2021 6:17 pm
by Glyn Ruck
Regarding Norman's concerns about brake fluid out of the vent hole, I simply glued a diaphragm across the lid seal. Works a treat.
Done as I posted this thread to anther forum.