enough is enough Car fumes ?

Orlando St.R · Post by **Orlando St.R** » Mon Nov 12, 2018 6:38 pm

So, have you managed to improve or resolve the fumes situation at all, John?

Orlando St.R · Post by **Orlando St.R** » Mon Nov 12, 2018 7:16 pm

By the way, if anyone has an original scuttle vent outlet pipe (BD10370) installed, please could they upload a pic of the routing of it? I have installed my nice new one from SNGB, but it seems perilously close to the exhaust manifold.

Thanks ever so in anticipation.

Jose · Post by **Jose** » Mon Nov 12, 2018 8:33 pm

is it just hanging down? it should be held to the firewall with existing bendable tabs following the curvature of the firewall or bulkhead.

johngosnell · Post by **johngosnell** » Tue Nov 13, 2018 8:29 am

Car not driven yet, But with what has been replaced I am confident. Items replaced were scuttle vent pipe, engine breather filter, a couple of sealing rubbers on the fire wall and a replacement Boot seal.

john

1B1257BW

Orlando St.R · Post by **Orlando St.R** » Tue Nov 13, 2018 6:03 pm

Fingers crossed, then, John. Let us know how you get on.

Jose, that's what I did, but there is less than an inch between the tube and the exhaust manifold. See pic. That said, it may all fit better when I have replaced the heater pipes with the correct ones and hooked the rear one properly under the heater box.

Jose · Post by **Jose** » Tue Nov 13, 2018 7:28 pm

Orlando it should be routed towards the transmission tunnel, the way you have it outside of the tunnel is not the correct routing.

by the way that is a nice clean engine compartment, and you have the correct C19704 Heater Valve.

Orlando St.R · Post by **Orlando St.R** » Wed Nov 14, 2018 4:15 pm

Ah, okay. Thanks for the advice, Jose. As before, if anyone can provide a photo of their install, it would be greatly appreciated.

And hands off my NOS heater valve.

Jose · Post by **Jose** » Wed Nov 14, 2018 4:26 pm

better not let Cass see it!

the hose I have is not the original BD10370, it's one I made up with a heater hose. I will get a picture of it asap.

cass3958 · Post by **cass3958** » Wed Nov 14, 2018 8:16 pm

Jose wrote: ↑Wed Nov 14, 2018 4:26 pm better not let Cass see it!

No jealousy here. I do not crave a C19704 Heater Valve but it would be nice to have one that worked.
Must buy the vent tube and fit it though. Thanks for the info.

Glyn Ruck · Post by **Glyn Ruck** » Thu Nov 15, 2018 3:45 am

: a0482430-d371-4271-93e8-affdf4407a18.png (36.47 KiB) Viewed 2865 times

THE INTERNATIONAL JAGUAR 'S'-TYPE REGISTER FORUM

enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Re: enough is enough Car fumes ?

Last 100 Members Who Visited This Topic. Total 334 visits

Who is online