THE INTERNATIONAL JAGUAR 'S'-TYPE REGISTER FORUM

Mine was salvageable so I repaired it with some J B Weld, sanded and shaped to size,

Ok, I would like two.
thanks,
Lou


[quote=ALOBRY post_id=8267 time=1681674870 user_id=3926]
After the heater control knob broke (due to the inaccurate servicemanual!) I have replaced it with a plastic copy (3D printed) which fits perfectly and is indistinguishable from the original. Just to be safe I also made several spares.


Andrew
1964 3.8 manual o/d Jaguar Light Blue
[/quote]

Sensible solution. :D

Nice one Andrew. 3D printing is the way to go with some of the obsolete parts on our old cars. Where abouts are you based as you do not have a location in your personal details.

After the heater control knob broke (due to the inaccurate servicemanual!) I have replaced it with a plastic copy (3D printed) which fits perfectly and is indistinguishable from the original. Just to be safe I also made several spares.


Andrew
1964 3.8 manual o/d Jaguar Light Blue

Lou I have some spares in the attic but not the levers They are Bakelite and become brittle with age. I might be able to help with the escutcheon for
the Rear Vent but I will have to go and have a look in the morning and come back to you.

I also need two of the heater knobs, one for the dash control lever and one for the console lever.
I need the escutcheon also on the console for 'Rear Vent' BD25840

If you only have only one, I can get it reproduced and returned to you.

thank you,
Lou
Daisy, Pale Primrose, 3.8s, manual o/d
San Diego California